1. REPLACEMENT FOR POP-ON CAPS
If you have pop-on hubcaps, removing and replacing your wheel coverings is simple. Before you begin the project, make sure your car is parked on a flat surface and the motor is not running. Also, engage the parking brake and chock the wheels.
Then, simply work two wide-end flat screw drivers onto opposite sides of the hubcap. Work your way around the hubcap until the cover pops loose. Then, install the new cap by placing it over the wheel and pressing firmly on opposite sides. You may need to gently tap each new pop-on hubcap into place.
2. REPLACEMENT FOR SCREW-ON CAPS
Screw-on caps have a plastic nut that attaches to your vehicle’s existing lugs. Replacing this type of hubcap is also easy, as you only have to unscrew each plastic nut to remove the hub cap. Again, protect yourself by parking your car on a flat surface, engaging the parking brake, and chocking the wheels.
After you have removed the plastic components, simply put the new hubcap into place. Then, tighten each plastic nut. Do not use a power tool for this project though. Doing so may over-tighten nuts, causing them to track and fail.
If your vehicle has screw-on caps, you should realize that plastic nuts may work themselves loose over time. Because you do not want to lose your hubcaps, periodically check the tightness of the plastic nuts that hold each hubcap in place. If you notice looseness, hand tighten the nuts to keep your hubcaps secure.
3. REPLACEMENT FOR BOLT-ON CAPS
Replacing bolt-on hubcaps is a bit more involved than the other types of hubcaps. Still, if you have old, damaged, or unattractive wheel coverings, you need to know how to put on hubcaps on your vehicle. After preparing your vehicle to prevent rolling (flat surface, parking brake, wheel chocks), you are ready to begin.
First, pick a lug nut and use the wrench that came with your vehicle’s jack to turn it counterclockwise. Do not completely remove the lug nut, though, Instead, only loosen it.
Then, move to the lug nut on the opposite side from the first lug nut you loosened and loosen it. After loosening opposite lug nuts all around the wheel, remove each lug nut one-by-one. Be sure not to loosen the plastic washers that are with each lug nut. Do not remove the tire.
After you have removed the lug nuts and washers, your hubcap should slide off the wheel. If you have built-up gunk, though, the hubcap may be a bit stuck. Therefore, you may have to use a flat screwdriver to work the hubcap loose. After the hubcap is off, you can slide the new hubcap onto the exposed lug nuts.
Once you have the new hubcap in place, you are ready to reattach the lug nuts. Start by screwing each nut into place with your hands. When doing so, be careful not to cross thread the nuts. If each nut does not screw onto the lug easily, you may not have the threads lined up quite right.
After hand tightening each lug nut, grab your lug wrench. Working in an opposite pattern, tighten each lug nut. Then, go around the wheel in a circular pattern to be sure each lug nut is firmly tightened. If you are replacing more than one hubcap, repeat the process on each wheel.
“Keyword”
“golf cart hubcap spinners”
“golf cart hubcap clips”
“yamaha golf cart hubcap”
“how to take a hubcap off a golf cart”
“golf cart hubcaps”
“golf cart hubcaps spinners”